Power Output Testing

Power output was measured using a Surecom SW-33 Plus into a dummy load. The radio was set to maximum power. The ITU guidelines for spurious emissions require measurements of "the power (W) supplied to the antenna transmission line".  That requirement makes this separate power measurement necessary, as it is incorrect to measure relative to the fundamental (f0).  All numbers have been rounded.

Spurious Emissions Testing

Spurious emissions were measured using a Tiny SA Ultra.  The radio was set to maximum power and was connected to the TinySA through an attenuator. It is important to understand that the graphs below are using a decibel scale, not a linear scale.  If a spurious emission spike appears to be almost as tall as the fundamental, that does not mean it is emitting almost as much power.  Refer to the raw data shown. 

Comments